Coastal Current Marine Electrical
(828) 384-9259 Request Service
Request Marine Service Call (828) 384-9259
A finished helm switch panel and Victron inverter stack installed cleanly aboard a vessel

Home/Our Work

Our Work

The standard behind every installation.

A look at how Coastal Current builds, wires, and finishes marine electrical systems, panels, power systems, harnesses, and refits, and the real jobs below that back it up. Every project was diagnosed, documented, and signed off to applicable ABYC standard.

6

Electrical Disciplines

7

NC Coast Service Areas

100%

ABYC-Standard Work

Mobile

Dockside, Every Job

The gallery

Real jobs, photographed on the vessel. Not staged, not stock.

Full helm electronics integration with chartplotter, radar, and instrument displays
Marine Electronics

Full helm instrument integration

 Victron MultiPlus inverter, MPPT solar controllers, and Cerbo GX monitoring installed together
Off-Grid & Lithium

Victron inverter & monitoring stack

 Organized wiring bundles run through a bulkhead during a vessel electrical refit
Refit

Helm wiring bay, bundled and labeled run by run

 Rows of labeled ring terminals landed on tinned bus bars inside a custom-built panel
Electrical Surveys

Labeled terminals, ready for inspection

 Clean marine battery bank installation with organized wiring
Off-Grid & Lithium

Rebuilt battery bay, organized and labeled

 Old wiring spliced with cheap plastic wire nuts, cracked tape, and a corroded terminal
Before

Illustrative: what a neglected wiring job looks like

 Backlit overhead switch panel for spreader lights, map light, and accessory circuits
Marine Electronics

Custom overhead switch panel

 Blue Sea circuit breaker panel and bus bars wired inside a distribution enclosure
Electrical Systems

Blue Sea distribution panel

 A custom 240V AC and 12V DC distribution panel, built and bench-tested before installation
Power Management

Custom AC/DC distribution panel, shop-built

 A center console's switch panel wired and labeled for spreader lights, bilge, livewell, and accessory circuits
Marine Electronics

Console switch panel, wired and labeled

 A custom distribution panel dry-fit and laid out on the bench before a single wire is run
Power Management

Dry-fit and planned before a wire is run

 The same custom distribution panel, fully wired and labeled to ABYC standard
Power Management

Same panel, wired and finished

 Bus bars and terminals laid out on a custom panel before final assembly
Off-Grid & Lithium

Bus bars, laid out before assembly

 Victron inverter and monitoring stack wired and tested under a work light
Off-Grid & Lithium

Victron stack, wired and tested

 Internal wiring inside a distribution panel enclosure, organized and labeled
Electrical Systems

Inside a distribution panel enclosure

Want work like this on your vessel?

Request Marine Service Call (828) 384-9259